Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hello Everyone, I'm working on NX

Status
Not open for further replies.

Khaledtr

Automotive
Sep 4, 2022
3
Hello Everyone,
I'm working on NX 12 and I'd find a method to insert the assembly mass to the drawing/title block via an attribute, what I understood that the only way is to use a journal. I find something interesting in this Thread thread561-485834 and I tried to apply the suggested journal by Mr.niedzviedz (Mechanical) Just I'd modify this journal to make it write the attribute of mass (mass.prt) to the assembly instead of part and this attribute must be the sum of the mass of parts to be able to use it in the drawing.
Thanks in advance
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor