Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

help engraving with a han-kwang laser 4000w

Status
Not open for further replies.

laserg12

Industrial
Aug 8, 2013
2
US
We have a 4000w hankwng and we are trying to do engraving on stainless. the quality is not good.
We are using a 5" focal lens do you think a smaller focal length will help in a better quality.like a 3.75" focal lens?
any tips please?
 
Replies continue below

Recommended for you

What kind of quality are you getting? Slag and burrs on the top? You could have your focus incorrect, power too high, feed rate too low and gas pressure too low.
-HR
 
The assist gas type can also have an influence. Post a picture of the results you are getting. It'll be much easier to help you then.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top