Help with the tool body trim

[ARPERO]

Hello good day.
As it is I hope and I can help with the following query
E NX6 been working with. Modeling a piece through surfaces (plates)
But the problem arises when I try to cut one sheet against another
When I apply the body trim tool send me the error (HAART Do Not intersect.
Edit or Targed the tool to completely intersect.)
What could be.
I have attached a picture of model
Regards

 

[JohnRBaker]

I assume the 'green' body is what you're using to Trim the 'orange' body, correct? If so, perhaps you need to extend the 'green' body so that it goes past the bottom of the 'orange' part.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.