Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hiding / disabling the "Back" and "Cancel" buttons in BlockS 1

Status
Not open for further replies.
MarckyMON

MarckyMON

Computer
Nov 30, 2010
93
Hi,

I am currently working with the BlockStyler in NX 7.5.1.5 x64 using C++. By default, the "OK", "Back" and "Cancel" buttons are displayed in the dialog group. For the life of me I cannot figure out (and there is no mention in the documentation) how I can either disable or hide these buttons either interactively or programatically. I do know that this was possible in the old UIStyler, but since the BlockStyler offers controls that I need (e.g. the tree block), I cannot switch to the UIStyler.

Is there any possibility to hide/disable the standard buttons at all, so that only the "OK" button is displayed? Or will they need to stay?

Any insight is greatly appreciated, thank you!

Marc
NX Software Developer
 
Status
Not open for further replies.

Similar threads

Asieros
  • Locked
  • Question
Siemens NX Drafting - Reset the "Border to Arrow Distance"
Replies
0
Views
466
Asieros
Asieros
MANox
  • Locked
  • Question
Change tabs bar posiotion to "centered"
Replies
2
Views
218
MANox
MANox
Anton Liubimov
  • Locked
  • Question
NxOpen, How to programmatically open a dialog box "Extrude"
Replies
2
Views
409
Anton Liubimov
Anton Liubimov
DDerek
  • Locked
  • Question
How to make "Balloon" Result in only the number for the callout
Replies
3
Views
220
SDETERS
SDETERS
esikoglu
  • Locked
  • Question
thePart.CAMSetup.CAMGroupCollection.FindObject("MCS_MILL"); cannot find the object
Replies
0
Views
97
esikoglu
esikoglu

Part and Inventory Search

Sponsor

Back
Top Bottom