thread247-237287
In the previous thread (linked above because it's now closed), I asked a question about matching network design. I had been using a temporary short to measure the electrical delay. biff44 said this...
"Certainly above 2.5 GHz, I would use a more accurate method than just dropping in a temporary short."
I was wondering if anybody had recommendations for a more accurate method?
In the previous thread (linked above because it's now closed), I asked a question about matching network design. I had been using a temporary short to measure the electrical delay. biff44 said this...
"Certainly above 2.5 GHz, I would use a more accurate method than just dropping in a temporary short."
I was wondering if anybody had recommendations for a more accurate method?
