Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

High point vent required at mdea solution pump discharge

Thread starter KVVS
Start date Mar 14, 2011

Status: Not open for further replies.

Mar 14, 2011

KVVS

Chemical

Hi all

I have to check isometrics of CO2 removal section. during checking of aMDEA solution pump discharge line isometric , i found out a high point vent is provided. i little surprised to see the same .
can be apply this normal practice in aMDEA solution too.

please help me.

thanks in advance