Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

High Pressure Small Vessel

Status
Not open for further replies.
juancito

juancito

Mechanical
Nov 30, 2000
64
I´m going to design a small pressure vessel with a design pressure of 2600 psig.
Any recommendation? Where can I get the MAWP of threaded couplings?
Thanks in advance
 
Replies continue below

Recommended for you

Sort by date Sort by votes
ASME SecVIII Div 3, ASME B16.11
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

E
  • Question
Thin Walled Pressure Vessel
Replies
4
Views
1K
TGS4
TGS4
teokal
  • Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
319
teokal
teokal
mariolucas75
  • Locked
  • Question
ASME pressure vessel internal pitting weld build-up repair 1
Replies
7
Views
347
mariolucas75
mariolucas75
Virendra Patel
  • Locked
  • Question
Replacement of same pressure vessel part (HX bonnet) needs only R-1 report. 1
Replies
2
Views
252
rachnatbovo
rachnatbovo
kremenco
  • Locked
  • Question
Should the Jacket of a Cryogenic Vessel be considered as pressure vessel?
Replies
7
Views
192
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top Bottom