Hole callout issue, please help

[Trent5791]

I can't get the hole callout feature to work for a tapped hole on a cylindrical surface. The 1/4-20 hole in the middle view of the attachment was labeled with a Note because I could not get the hole callout feature to work on that hole. Please help.

Thank you,
Trent
NX 9.0.3.4

 

[NutAce]

Yep...Doesn't work when a Hole is placed on a cylindrical/conical face.
Fixed in NX11.0.1


Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX11 / TC11

 

[Trent5791]

Yet another short coming of NX. It seems to be riddled with them, especially on the drafting side.

Thank you,
Trent
NX 9.0.3.4

 

[SMO]

Trent5791,

Did you try using the ol, Feature Parameter command (example attached) It's worth a try..


Regards,
SMO (NX10)