Hole Callout Precision

[bhart]

Is there a way to get an independant # of decimals on the diam. & depth of a hole in a callout (differing decimals = different tolerance on diameter vs. depth)?

 

[SBaugh]

No you can't at this time - It's a limitation.

Try running a search in this group. This has been discuss many times.

thread559-62976
thread559-86931
faq559-891

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376

 

[bhart]

I did the search before I posted and I found that you could not put a different EXPLICIT tolerance on each dimension, but the tolerance I am talking about is implicit based on our drawing standards.
3 decimals = +/- .005
2 decimals = +/- .01
Oh well, I guess that's not possible either.

 

[MElam]

You can select the hole callout and change the precision in the PM, but you do have to do it for each callout.