Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole dimension tolerances on prints

Status
Not open for further replies.
bearisle

bearisle

Mechanical
Jun 2, 2004
77
0
0
US
Might not be in the right forum....I am looking for a good way to put a blanket statement in my title block to cover HOLE dimension tolerances. I currently use linear dimensions as follows
x.x = +/- 0.1
x.xx = +/- 0.015
x.xxx = +/- 0.005
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Mike Mike
  • Locked
  • Question
Dimension randomly changes in autoCAD paper space
Replies
3
Views
32
Mike Mike
Mike Mike
Hamidreza1973
  • Locked
  • Question
execute the Mview command more than one time
Replies
0
Views
15
Hamidreza1973
Hamidreza1973
moon161
  • Locked
  • Question
How to suppress phi symbol in AutoCAD LT dimensions? 1
Replies
4
Views
18
moon161
moon161
ohiocad
  • Locked
  • Question
Non-typical dimensioning stretches
Replies
9
Views
29
structuralCADspecialist
structuralCADspecialist
ohiocad
  • Locked
  • Question
More Autocad 2019 dimensioning
Replies
1
Views
12
Sparweb
Sparweb
Back
Top