Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole labelling & notation.

Status
Not open for further replies.

Engineeeeeeeeer

Mechanical
Joined
Jul 20, 2004
Messages
43
Location
TH
I have a 2” square hollow section that will have two 16Dia round bars (& thus holes) though the x axis (view from end). My question is regarding the usual notation used when labelling these holes. Usually when labelling holes in flat plate I write ‘ 2-Dia17Holes’. However, when labelling hollow section, do you write ‘2-Dia17Holes’ or ‘4-Dia17Holes’ (as there are actually 4holes), or do you add ‘2-Dia17 Thru holes’? Must appreciate it if anyone can tell me the normal convention used.
 
I would say "2-Dia17Holes Through Both Sides" or "2-Dia17ThroughHoles" or "(2) 17mm Dia Holes Through Both Sides" or "17mm Dia Through Holes Through Both Sides in 2 Locations" Etc.
 
If you have 2 holes at 17 dia ... use "2X (DIA SYMBOL)17 THRU (or depth symbol with dim)".
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top