Hole table

[jackorsen88]

Hello

i'm trying to create a hole table and i have some dificulties:

1. Why are all holes have the same coordinate (Photo link)
2. I want to have only x and y coordinates in table and only diameter nothing else
3. How do i show origin as +x +y (not ORDINATE1). i have tried all the symbols but there is not one that could show the +x and +y directions

https://files.engineering.com/getfi...-4906-a7a6-37c63bd5d312&file=Zajeta_slika.GIF

https://files.engineering.com/getfi...4074-9063-ba68e1ab811c&file=Zajeta_slika2.GIF

 

[Toost]

1) Do you have multiple features at Position 1?
It seems there are 4 holes dia 10.4 there and 2 holes dia 5.3.
2) select the table top left corner, settings - Hole table- format - Show columns X and Y.
3) How should this symbol look ?


Note, you have both the hole table AND a full set of dimensions, this ...?

Regards,
Tomas

 

[jackorsen88]

i just wanted that the coordinate system of hole table is visible, because by default, it only marked ORDINATE. You dont know where the positive or negative side is.
The only option was, that i create the coordinate system where i wanted, put it on the layer, make the hole table based on that coocrdinate and system and then make the layer visible on the view.

Thanks

 

[Toost]

Is there a standard for showing / marking the origin/zero of a hole table ?
You can edit the ordinate dimension and create two "zero dimensions" ( = "0") if that is ok.

Custom Symbol ?

Regards,
Tomas