Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
hole wizard leader/text gap?
- Thread starter mathey
- Start date
- Thread starter
- #2
news update...
the actual text of the note read as such:
<NUM_INST>X <MOD-DIAM> <hw-diam> <hw-thru> <dim>
What is the <dim> for at the end? Removing it solves the problem, but why is it there? The calloutformat.txt file appears to be correct...
the actual text of the note read as such:
<NUM_INST>X <MOD-DIAM> <hw-diam> <hw-thru> <dim>
What is the <dim> for at the end? Removing it solves the problem, but why is it there? The calloutformat.txt file appears to be correct...
- Thread starter
- #3
update 3...the <DIM> appears to be a placeholder for a tolerance...the gap only appears when the leader tail is to the right of the text...so its holding a space for the tolerance, even tho there is no tolerance in this situation...
SW 2005 0.1
SW 2005 0.1
- Status
Similar threads
- Locked
- Question