Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hot Taps: Test Vessel Vs. Field Operation Issue

Status
Not open for further replies.
John7474

John7474

Petroleum
Jan 10, 2012
34
My hot tapping cutter actuating drive stops after 700 psi although the machine is rated for 1480 PSI. It works fine at STP. It also works fine in the field under pressurised condition.

Any suggestions?
 
Status
Not open for further replies.

Similar threads

Ahmed Elarbagi
  • Locked
  • Question
Hot Oil (PetroTherm) system operating pressure vs end users operating pressure
Replies
4
Views
3K
GD2
GD2
R
  • Question
Air assisted seal pressure vessel
Replies
3
Views
4K
btrueblood
btrueblood
JouHar
  • Locked
  • Question
Flange bolt stress and torque at 20° C vs. at operation temp of 300° C
Replies
2
Views
258
GD2
GD2
mahmoud kassab
  • Locked
  • Question
above ground pipeline deflection issue 1
Replies
14
Views
634
LittleInch
LittleInch
X
  • Question
B16.5 Max Flange Hydrostatic Test Pressure
Replies
8
Views
6K
TGS4
TGS4

Part and Inventory Search

Sponsor

Back
Top Bottom