How add column on B.O.M. table

[alexasa]

I need to add in PART LIST another columns with diferent description about part IE.(drawing number,material,dimensions, etc)

 

[hodgo2]

Sorry alexasa not sure what you mean. Do you want to add these columns in to your assembly Navagator?

If so you can create columns in this by going too
Preferences > Assemblies > Configure Columns...

 

[alexasa]

No, I have an Assembly drawing with explosive view, and I put a Part list of my assembly but, that B.O.M. or part list have only 3 columns. I need add more columns with data title like material,drawing number, dimensions of eaah part listed.

 

[lsl49]

If you are using NX2 - Here is one way - When in Drafting and you are looking at the BOM. Place cursor over the top and the column should 'High Light'. With it near where you want to add a column, 'Right Click'. You should see 'Add Column To Right' - 'Add Column To Left'. Select your preference.
Hope this helps.

Larry Leonard
Designer
Smith-Nephew Orthopaedics