Woifi
Automotive
- Feb 7, 2024
- 1
Hello,
I have two truncated cones with the same starting point. The cones need to be substracted from a body for a screw hole. Due to different tooling directions of the part and the one it should be attached to, they have a different drafting direction.
If I just create the two cones an edge is created (see picture).
I wanted to ask you what would be the easiest/cleanest way to get a smooth hole.
(I am using NX2212)
Thank you!
I have two truncated cones with the same starting point. The cones need to be substracted from a body for a screw hole. Due to different tooling directions of the part and the one it should be attached to, they have a different drafting direction.
If I just create the two cones an edge is created (see picture).
I wanted to ask you what would be the easiest/cleanest way to get a smooth hole.
(I am using NX2212)
Thank you!