Hi I want to make a dependent mesh, but on one edge the surface goes over the edge and I get an error message when I try to make the dependent mesh. I tried to fix it with the "Merge face" and "Split face" commands, but it is always the same. Has anybody an idea what I can do?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How do i fix the problem with this edge? 1
- Thread starter nxprouser
- Start date
-
1
- #2
BlasMolero
Mechanical
Hello!,
You can issue command "INSERT > MODEL CLEANUP > RESET" and restore abstracted poligon faces & edges to its original state, but you will see a request of "MESHING UPDATE" and if you repeat the meshing job the problem will appear again, then not room this way. What you need to do is to set at zero in meshing command the option "MODEL CLEAN OPTIONS" that try to remove small features during meshing using a "Small feaure Tolerance (% of element size)". Move the slider to value 0.000 and you are done, OK?
Best regards,
Blas.
~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director
IBERISA
48004 BILBAO (SPAIN)
WEB: Blog de FEMAP & NX Nastran:
You can issue command "INSERT > MODEL CLEANUP > RESET" and restore abstracted poligon faces & edges to its original state, but you will see a request of "MESHING UPDATE" and if you repeat the meshing job the problem will appear again, then not room this way. What you need to do is to set at zero in meshing command the option "MODEL CLEAN OPTIONS" that try to remove small features during meshing using a "Small feaure Tolerance (% of element size)". Move the slider to value 0.000 and you are done, OK?
Best regards,
Blas.
~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director
IBERISA
48004 BILBAO (SPAIN)
WEB: Blog de FEMAP & NX Nastran:
- Status