Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How do I model aircraft cable in RISA 3D?

Status
Not open for further replies.

Jimboliscious

Structural
Jun 10, 2009
6
Has anybody modeled aircraft cable in RISA 3D? What should I use for Allowable Yield Stress, Fy? Would it be the breaking strength divided by the area? Seems that would be the Fu tensile stress.
 
Replies continue below

Recommended for you

I think that more than a RISA question it is a "technical" question. So the cable will have some intent and more or less defined setup, and a someway defined envelope of loading hypotheses. So how you model such something will depend upon all these things. In some cases the design of cable structures involves iterative steps; this also can be used within RISA even for large deformations (geometrical nonlinearities) that of course are not the intent of a program like RISA, but you can approach it by such iterative procedures. Respect a single straight cable you have a tension-only element in RISA-3D; this will help you to not get some problems in analysis when using cables and a number of hypothesis. Yet for a special hypothesis that ensures tension you can model the cable, use P-Delta and have a nice approximation (for problems that not require the iterative process referred above) of the standing stress for the hypothesis. That you may want to compare it to a fraction of Fu or to Fy or whatever will depend of your technical intent. If you throw your cable-like element to RISA under a code, RISA will try to check it as per the code.
 
The USS Steel Wire Rope publication provides some values for cables. They provide breaking strength and the E for structural steel. There are also a number of design recommendations.
 
Correction:

The USS Steel Wire Rope publication provides some values for cables. They provide breaking strength and the E for the cable. Typically the E for cable is less than that of structural steel. There are also a number of design recommendations.

 
Thanks Oldrunner. This lead me to a similar post with the attached manual I believe you are speaking of. Here's the thread to find the attachment.

thread507-239603
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor