Jun 2, 2009 #1 williwang Mechanical Nov 8, 2008 72 0 0 AU Good day, everyone!! Can anyone tell me how part axis system(s) can be shown in a drawing view? I know how to show points, lines, but not axis systems. Thanks!!! Forever Young.....
Good day, everyone!! Can anyone tell me how part axis system(s) can be shown in a drawing view? I know how to show points, lines, but not axis systems. Thanks!!! Forever Young.....
Jun 3, 2009 #2 1oldcaduser Automotive Jun 3, 2005 79 0 0 SE As far as I am aware you cannot show the axis. When you set up the view if you select the axis as your origin the when the view is active you will see the axis which is the same as the 3D. Upvote 0 Downvote
As far as I am aware you cannot show the axis. When you set up the view if you select the axis as your origin the when the view is active you will see the axis which is the same as the 3D.
Jun 3, 2009 #3 engjeff Automotive Apr 24, 2007 84 0 0 US In Options>Mechanical Design>Layout> "View axis system based on 3D axis system" Upvote 0 Downvote
Jun 3, 2009 Thread starter #4 williwang Mechanical Nov 8, 2008 72 0 0 AU Thanks, My configuration is MD2, so, I think I can not do it. Forever Young..... Upvote 0 Downvote