How to add a surface to sketched boat hull

[GaTechDan]

I was wondering if anyone could point me in the right direction of how to cover the attached geometry with a surface. I'm very inexperienced with NX so any input would be appreciated.

Take care!

 

[JohnRBaker]

Here's one solution...

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[hudson888]

I'll admit that John's solution looks a lot like what I suppose that you think you wanted, but then again it looks like you might want to shell out the hull to 0.0625 inches thick. If you're interested in the sort of thing that you'd need to do in order to achieve that then take a look at the attached file.

Best Regards

Hudson

www.jamb.com.au

Nil Desperandum illegitimi non carborundum