Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to add bulk components in to the assembly.

Status
Not open for further replies.
Vikas4auto2019

Vikas4auto2019

Mechanical
Sep 23, 2019
13
I wanted to add 800+ components to the assembly.
constraining is not important here. just being that all part in a single assembly is imp. in this case.

Can anyone suggest the easiest way to drag all parts from the folder into the assembly?
Using Solid Edge 2020 classic

Thanks in advance.
 
Status
Not open for further replies.

Similar threads

J
  • Locked
  • Question
VBA to Pull Total Surface Area and Volume for a Part of an Assembly?
Replies
0
Views
1K
jdconnel
J
NirVidP
  • Locked
  • Question
How to 'Create Part In Place' using vba?
Replies
0
Views
848
NirVidP
NirVidP
jcpalekar
  • Locked
  • Question
How to handle occurrence properties of solid edge through excel sheet?
Replies
0
Views
883
jcpalekar
jcpalekar
dakeb
  • Locked
  • Question
Assembly Save As
Replies
2
Views
864
dakeb
dakeb
RC-o2
  • Locked
  • Question
The rollback event cannot allow saving of the active document because we could not get valid pointer
Replies
0
Views
730
RC-o2
RC-o2

Part and Inventory Search

Sponsor

Back
Top Bottom