How to Change Step Value Globally

[riveter1]

When placing a line, point, etc. I like to use the up and down arrows to increment the distance values. In Catia, it is set to 1 inch which is too big for the work I do. I can change the step value, but it defaults back to 1 inch. Can I set it to 1/32 inch and make it stay 1/32 inch? See attached screenshot.

Mark

 

[jenalynn]

If you go to tools,options,sketcher, you can change the grid primary spacing, and graduations, to the size you need. I hope this helps. Rod.

 

[riveter1]

I set my primary grid spacing to 1/16 inch and found the spinner is not affected by grid settings. It still defaults to 1 inch.

Mark

 

[DBezaire]

Mark, there is no setting for the incremental values and it will stay active in the current session only.

Regards,
Derek

 

[riveter1]

Thanks Derek.

Mark