Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to configure the plotting interface?

Status
Not open for further replies.

Pjone kenobi

Mechanical
Sep 19, 2018
44
Hello!
I try to connect my OCE CW650 PRINTER.
I want to launch the pilot application because as I use a folding machine (integrated on my printer) I need to paramter it.
My problem,I don't know how to connect it.
Could you help me please?

Best regards
Capture2_xggall.jpg
 
Replies continue below

Recommended for you

Didn't you already asked this question in below posting?

[URL unfurl="true"]https://www.eng-tips.com/viewthread.cfm?qid=444465[/url]

Looks like nobody has the answer for you.
Best bet for you would be to go through the helpfiles from NX. There is a whole section on configuring plotters and printers.
Also in my opinion, the properties displayed by the printer are coming from the Manufacturer's driver software. Don't think NX will be able to make any changes in there.



Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11
 
Good Luck. I like NX a lot, but setting up a plotter has always been painful. We gave up a long time ago, so maybe it's gotten better.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor