Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

how to create a flat pattern or form board of a ug model NX6 wire

Thread starter coldplay112
Start date Feb 1, 2011

Status: Not open for further replies.

Feb 1, 2011

coldplay112

Electrical

hi guys,
I am new to unigraphics NX6 world. I need to create a flat pattern for a wire / cable assembly model in UG. I need procedures and tips or tutorials. I cant figure out how to create the pattern and my wire harness has plugs and lugs on them. please help a novice one. thanks

coldplay112