Helepolis
Mechanical
- Dec 13, 2015
- 198
Hi,
I want to incorporate a Molded-In Insert to one of the products I'm working on, but this is my first go at it so I'm not sure how to design the area of the part where the insert will be embedded.
For the ultrasonic assembly inserts there are hole size recommendations from the manufacturer but for the molded-in i can't find anything specific, the only thing i managed to find is that the material outer diameter around the insert should be at least 1.5D (where D is the outer diameter of the insert) but not sure how accurate this info is.
And another thing is how to make the correct annotation for molded-in insert in a drawing.
Thanks.
I want to incorporate a Molded-In Insert to one of the products I'm working on, but this is my first go at it so I'm not sure how to design the area of the part where the insert will be embedded.
For the ultrasonic assembly inserts there are hole size recommendations from the manufacturer but for the molded-in i can't find anything specific, the only thing i managed to find is that the material outer diameter around the insert should be at least 1.5D (where D is the outer diameter of the insert) but not sure how accurate this info is.
And another thing is how to make the correct annotation for molded-in insert in a drawing.
Thanks.