Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to determine material group in NACE MR0175 ?

Status
Not open for further replies.
Aug 30, 2012
204
How to determine material group in NACE MR0175 ?

Supplier stated ASTM A350 LF2 fit for NACE sour service.
Upon checking in table A.1 , there was no information.
There was also no equivalent UNS number for A350 LF2 .

How to cross check information given by this supplier and confirm it is NACE compliant ?

image_2023-02-15_212152258_ss2uwl.png
 
Replies continue below

Recommended for you

Ask the supplier to provide equivalent material for A350 LF2.
Else, use your judgement.

DHURJATI SEN
Kolkata, India


 
rQuestionEngineering said:
Upon checking in Table A.1

In which part of the document. Part 2 for carbon steels doesn't use UNS numbers, and Table A.1 is for welds.

For carbon steel, you check for compliance by reviewing the inspection documents and verifying that the chemical composition, and the hardness measurements made on the material meet the acceptance criteria.

Get yourself some help.

Steve Jones
Corrosion Management Consultant


All answers are personal opinions only and are in no way connected with any employer.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor