how to do multi section surface/solid without curing the edges

[NIMANIMAX72]

hi
i want to do a multi section between two section(a circle and rectangle) with two guides(a line at top and a curve in bottom) after doing this edges on the right and leftbecame curved instead of going straight.(without guides it is fine and straight)

https://files.engineering.com/getfile.aspx?folder=320937b0-f20c-4ac9-b245-e02bcbca7f2d&file=01.JPG

https://files.engineering.com/getfile.aspx?folder=afbd5699-bf01-45b0-a3c6-119de5b89784&file=02.JPG

how can i solve this problem?

 

[jackk]

If it's fine and straight without the guides, then don't use the guides.

Or, use straight lines for the guides.

 

[NIMANIMAX72]

NO
I need it to be curved at top angled at bottom and straight at sides

 

[itsmyjob]

why don't you bring picture in your post the right way?

Eric N.
indocti discant et ament meminisse periti ​

 

[itsmyjob]

why don't you force the curve edges to go straight by declaring guide curves?

Eric N.
indocti discant et ament meminisse periti ​