How to draw a Wave Spring Washer in Geomagic Design

[RowlyC]

Hi All, I am new here.
I just need a bit of advice on How to draw a Wave Spring Washer in Geomagic Design.
I have found Youtube Vid, on how to do it in Solidworks.

https://www.youtube.com/watch?v=PX3-6V3rau8

But i Cant achieve it yet, in Goemagic Design.
I just wondered, if was Possible in Geo, using similar technique, or am I wasting my time.
Any tips would be appreciated.
I need to be able to edit, No of waves, wave depth, Diameters & Thickness
Thanks
Rowland C

 

[berkshire]

RowlyC
Try your question at

http://forum.alibre.com/

You may get a better answer there.
B.E.

You are judged not by what you know, but by what you can do.