Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to mesh a pie-shape surface using structured mesh in DesignModeler?

Status
Not open for further replies.
Sacaq

Sacaq

Mechanical
Nov 4, 2014
42
Hi~

I want to mesh a pie-shape surface like this:
File:MG_initial_final.png


Is it possible to mesh a surface in DesignModeler like we do in Gambit?
For example, first distribute some points on each edge and then mesh the surface by using the points.
Thank you!
 
Status
Not open for further replies.

Similar threads

andradesilva
  • Locked
  • Question
modal analysis in ANSYS Mechanical APDL 2020 R2: How to see graphical results without mesh/elements
Replies
1
Views
446
NRP99
NRP99
H
  • Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
2K
karachun
karachun
IJR
  • Locked
  • Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
501
IJR
IJR
Faraz1997
  • Locked
  • Question
How to reduce number of iterations in tabular data of transient thermal analysis
Replies
3
Views
467
NRP99
NRP99
PedroCarneiro22
  • Locked
  • Question
Mesh retain
Replies
0
Views
44
PedroCarneiro22
PedroCarneiro22

Part and Inventory Search

Sponsor

Back
Top Bottom