Jun 29, 2020 #1 flyiinghorse21 Structural Jun 13, 2020 3 how to obtain the mass matrix ,stiffness matrix and damping matrix after model analysis in ANSYS?
Jul 1, 2020 #2 petb Marine/Ocean Nov 1, 2005 120 Use the *DMAT-command or *SMAT-command in a command snippet in the Solution branch. Make sure that you turn off distributed solution or you won't be able to do this since the full-file containing these matrices will be split into pieces. [pre]!Stiffness *SMAT,MK,D,IMPORT,FULL,file.full,STIFF *PRINT,MK,Ksparse.matr !Mass *SMAT,MM,D,IMPORT,FULL,file.full,MASS *PRINT,MM,Msparse.matr !... and so on... use *DMAT for full matrix printout instead [/pre] Upvote 0 Downvote
Use the *DMAT-command or *SMAT-command in a command snippet in the Solution branch. Make sure that you turn off distributed solution or you won't be able to do this since the full-file containing these matrices will be split into pieces. [pre]!Stiffness *SMAT,MK,D,IMPORT,FULL,file.full,STIFF *PRINT,MK,Ksparse.matr !Mass *SMAT,MM,D,IMPORT,FULL,file.full,MASS *PRINT,MM,Msparse.matr !... and so on... use *DMAT for full matrix printout instead [/pre]
Jul 7, 2020 Thread starter #3 flyiinghorse21 Structural Jun 13, 2020 3 Thank you!petb Upvote 0 Downvote
