Apr 27, 2013 #1 ookt2c Mechanical Apr 27, 2013 2 http://tinypic.com/r/2vwigwx/5 I tried to mesh but it gave me an error. How do I partition this?
Apr 28, 2013 #2 corus Mechanical Nov 6, 2002 3,165 Extrude the edges at the end of the radius. Upvote 0 Downvote
Apr 28, 2013 Thread starter #3 ookt2c Mechanical Apr 27, 2013 2 But wont that change the dimensions of the part? Upvote 0 Downvote
Apr 28, 2013 #4 corus Mechanical Nov 6, 2002 3,165 Nope. Check the dimensions after you've done it if you're not sure. Upvote 0 Downvote
