Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to run this stimulation of a nozzle that create a vee flat pattern

Status
Not open for further replies.
NL_eng

NL_eng

Mechanical
Jan 6, 2017
3
How to run this stimulation of a nozzle that create a vee flat pattern?

15725533_10209622814261766_1228234072_o_1_uqwjxp.jpg

123_zt7vsa.jpg


i have these nozzle that have different outlet diameter, how to stimulate the flow when the fluid is discharged to the atm?
Thx A LOT!!!
 
Status
Not open for further replies.

Similar threads

H
  • Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
2K
karachun
karachun
Faraz1997
  • Locked
  • Question
How to reduce number of iterations in tabular data of transient thermal analysis
Replies
3
Views
452
NRP99
NRP99
IJR
  • Locked
  • Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
483
IJR
IJR
andradesilva
  • Locked
  • Question
How to export to a text file results of analysis with material non-linearities, for all the substeps
Replies
0
Views
176
andradesilva
andradesilva
andradesilva
  • Locked
  • Question
how to select a cross-section for a line built in Design Modeler in ANSYS workbench 2023 R1
Replies
0
Views
102
andradesilva
andradesilva

Part and Inventory Search

Sponsor

Back
Top Bottom