How to take output of Max tool reach Z from Postprocessor

[Bingos]

Hi

I have a question. how to find out Max Z travel in a program and output it in nc file automatically? So that the operator can set length for that tool.

 

[joycejo]

Attached is a .tcl routine I got from the Seimens BBS

http://bbsnotes.ugs.com/

It seems to work OK

John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO
www.myigetit.com

 

[Bingos]

Thank you verymuch for information,

After adding in to before motion, it is not giving any output...anything need to be modified in the proc...?

could you please explain how to go about it.

Thanks

 

[joycejo]

Read the instructions within the procedures.

There are 2 procedures. One goes in the before motion and the second goes at the end of program

John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO

http://www.myigetit.com

 

[Bingos]

Thanks its working...