Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to use Lame's parameter 'A' while converting x,y coordinate into zeta,eta coordinate (FEA)

Status
Not open for further replies.
Souvik Singh Rathore

Souvik Singh Rathore

Mechanical
Mar 1, 2021
1
DF_yrb97k.jpg
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

MK_0202
  • Locked
  • Question
How to Increase Minor Axis Bending for Rolled-H section 1
Replies
7
Views
7K
Agent666
Agent666
Ocman76
  • Locked
  • Question
How is the Buoyancy Reduction Factor Equation derived?
Replies
1
Views
718
IRstuff
IRstuff
Al James at General Atomics
  • Locked
  • Question
How can I get a good comparison between CETOL-6sigma versus 3DCS Tolerance software?
Replies
1
Views
755
IRstuff
IRstuff
JimSlice
  • Locked
  • Question
Incorporation of prototype drawings into design drawings and certification of drawings
Replies
0
Views
140
JimSlice
JimSlice
Yousif Alaraji
  • Locked
  • Question
Adams ability
Replies
0
Views
564
Yousif Alaraji
Yousif Alaraji

Part and Inventory Search

Sponsor

Back
Top Bottom