Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

HRSG Stack Silencer Material

Status
Not open for further replies.
TAGE

TAGE

Mechanical
Feb 24, 2003
25
0
0
TH
Dear Sir
Does anyone have any idea about the normal (suitable) material for the HRSG stack silencer or so called "buffer" installed INTERNALLY inside the stack?
Please share me your experience regarding this matter.

Thanks for your kind help
Best Regards
 
Replies continue below

Recommended for you

Sort by date Sort by votes
TAGE

If the temperature is less than about 550F, 304 SS should be suitable.

I have encountered thin walled SS liners used in power generating service

-MJC

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Ahmed Elarbagi
  • Locked
  • Question
Horizontal Direct Fired Heater Minimum Stack Height Requirements
Replies
3
Views
23
GD2
GD2
Sohail Sabir
  • Locked
  • Question
Duct Burner Design for HRSG
Replies
2
Views
3
FacEngrPE
FacEngrPE
waliq
  • Locked
  • Question
Nozzles in a stack - Corten Steel
Replies
6
Views
13
GD2
GD2
FPPE
  • Locked
  • Question
Air-Cooled Inconel 625: plugsheet gaskets material 2
Replies
9
Views
35
FPPE
FPPE
rachnatbovo
  • Question
Post-forming heat treatment(PFHT) for material grade 10H (Duplex & Supper Duplex) 6
Replies
12
Views
51
XL83NL
XL83NL
Back
Top