Abdullah hassan
Student
- Nov 11, 2024
- 1
Hello,
I have done a simulation in HTRI with small heat exchanger of 32 tubes, if i put the number of tubes as 32 (16 U-tubes) then HTRI gives output number of tubes as 32 but If i see the tube layout drawing, it is only giving me 12 U-tubes in a straight line instead of 45 staggered style.
Now when I try to change the U-tube layout by selecting Visibility > remove tubes ON and then converting the remove tubes to actual tubes then these news tubes generated are straight and I am unable to convert them to become U-tube?
Can anyone help me out in this matter?
I have done a simulation in HTRI with small heat exchanger of 32 tubes, if i put the number of tubes as 32 (16 U-tubes) then HTRI gives output number of tubes as 32 but If i see the tube layout drawing, it is only giving me 12 U-tubes in a straight line instead of 45 staggered style.
Now when I try to change the U-tube layout by selecting Visibility > remove tubes ON and then converting the remove tubes to actual tubes then these news tubes generated are straight and I am unable to convert them to become U-tube?
Can anyone help me out in this matter?
