Huge Project and Whole Drafts to Update (How?) 9

[3vans]

How do you do guys,
First of all I found this site very helpful but I couldn't find any useful tips on my issue; thus I am posting my problem here in this forum, hoping somebody assist me to handle it.

I was working on an NX project for the last two months, a few days ago I have manipulated and changed some of the models, no problem so far; I had changed and then exported my project's drafts one by one. After finalizing the project I've noticed those intricacies I had made earlier were not applied to the drafts. Now I have to update each and every draft in the project and export it again. why is that so difficult? The solution is a bit pain in the neck, sorry for that but I am spending my day to update those outdated drafts and still, I'm almost at the beginning.

Help me please, is there any other way to handle the issue in the NX software?

thank you so much,
Michael Evans,
Regards

 

[3vans]

to Mr. Toost,
It wasn't the most appropriate attitude expected from an engineer, I've questioned an issue in which I had a problem. When I had found the answer I shared it, however I am a bit sorry for being a bit sentimental in posting the solution here but that doesn't mean that I'm representing any other party but myself. As you would expect I've downloaded the trial, then decided what to do; so do you.
if being a newbie in a community is an embarrassment I rather like to be embarrassed instead of not questioning for the answer. you have accused me to be a newbie here, which I am; this wasn't the most appropriate answer.

p.s. I am representing myself I do not know who else you've accused in this forum to be a newbie; but surely I would like to migrate to EngineersEdge or sth like that.

Regards,
Why did I join to this community? to be accused maybe!!!

 

[jerry1423]

download the trial what ? from where ?

 

[nxprog]

I haven't used it myself, but wouldn't the refile_part utility handle this problem? Has anyone use this utility before?

NX 6.05.3/7.5.5/8.0