Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

HYSYS Dynamic Initialization

Status
Not open for further replies.

GaTechTheron

Mechanical
Joined
Jan 26, 2006
Messages
110
Location
US
I have a model that drifts a bit from my initial settings. Instead of going back to steady state to reinitialize I would just like to set the values.

I put a stream off by itself and specified the composition, temp, and pressure. I used this stream to initialize other streams. I had to do it this way because I didn’t have a suitable stream that was 100% vapor after running the dynamic model.

This isn’t working for me. 2 questions:
1. When is dynamic initialization done? Is this after cycling from stopped to start? Does it have to be “reset” to time zero?
2. Mine is failing but with no error, it just doesn’t reset to my values no matter what I do. Any suggestions?

Greatly appreciated !
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top