Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I am looking for information, say a

Status
Not open for further replies.
michiganmike

michiganmike

Chemical
Oct 27, 2000
2
I am looking for information, say a table, that lists circular ducts sizes (diameters) along with corresponding bolt hole pattern and number of bolts.

thank you
mike.ferrara@jacobs.com
 
Status
Not open for further replies.

Similar threads

H
  • Question
How to caculate heat gain for a lift ?
Replies
7
Views
933
goutam_freelance
goutam_freelance
eeprom
  • Locked
  • Question
Looking for high temperature psychometric chart
Replies
6
Views
182
eeprom
eeprom
leo31
  • Locked
  • Question
on/off chiller unit for a batch production 2
Replies
4
Views
313
Heaviside1925
Heaviside1925
Mark_B
  • Question
Controls/hydronics/Air handling project for deeper learning - input appreciated
2
Replies
27
Views
6K
HVAC-Novice
HVAC-Novice
M_J_S
  • Question
Derivation for 4005 in velocity pressure equation imperial units
Replies
0
Views
914
M_J_S
M_J_S

Part and Inventory Search

Sponsor

Back
Top Bottom