Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I m getting an ERROR in this ANSYS fiel as element length is zero

Status
Not open for further replies.

snkadati

Aerospace
May 29, 2012
6
what is mean by this. I created model in ansys only,by using co-ordinates, ...I applied pressure at the grid lines in model ..wt is solution?
 
Replies continue below

Recommended for you

In the Z direction lines i m getting element type as zero length
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor