EvanDH
Mechanical
- Sep 30, 2010
- 33
thread559-187566
Hi,
I have same exact question as original poster in the thread reference aboove.
except I am using SW2010.
I have execute step 1. in the 4th reply, but do not see how this help me find the rolled back parts. The assembly opens with the same prompt?
I have execute procedure in 5th reply. The problem is, I do not get a dialog as described in step 4. Further, the statement after "voila!" does not describe the behaviour I observe.
Rather, I am again only prompted by "This document contains other parts and/or assemblies that were saved in a rolled back state. Do you want to roll them forward?", with no indication as to which part(s) and/or assembl(y/ies) it may be referring.
Can someone help me?
Hi,
I have same exact question as original poster in the thread reference aboove.
except I am using SW2010.
I have execute step 1. in the 4th reply, but do not see how this help me find the rolled back parts. The assembly opens with the same prompt?
I have execute procedure in 5th reply. The problem is, I do not get a dialog as described in step 4. Further, the statement after "voila!" does not describe the behaviour I observe.
Rather, I am again only prompted by "This document contains other parts and/or assemblies that were saved in a rolled back state. Do you want to roll them forward?", with no indication as to which part(s) and/or assembl(y/ies) it may be referring.
Can someone help me?