Importing a model

[irishcanadian]

Hello,
I am trying to import an orphan mesh into Abaqus that was meshed using NetGen. It was exported and saved as an Abaqus file (.cae) but when I try to open it in Abaqus there is an error message stating that it is unable to open the model either because the database needs updating or the file is corrupt. Any suggestions?

 

[IceBreakerSours]

Isn't it possible to mesh your geometry in CAE? Why use NetGen? Also, if you can save your output as an INP, that will resolve the issue (since INPs can be imported in to ABAQUS without worrying about which version you are using).

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083

 

[IKRAMLGMENIM2012]

hi , i'm trying to simulate turbulent flow problem using ABAQUS/CFD in fact i have to modulate a round jet (in outlet ant inlet), i'm using K-epsilon as a turbulence model . when i build the numerical model the job statue is fixed on "Submitted" abusively there is a contradiction in the model's data and i can't figure out the reason behind .any one can help me pleas ?