Ali Kara
Mechanical
- Mar 28, 2008
- 12
Hi everybody, I have a problem with importing a model from SolidWorks 2009 to ANSYS Classic. My cad model consists a revolve as a main feature and also some patterned holes on cylindirical surface of revolved body.
First problem is; ansys represents my holes(of course those are cylindirical holes) with two circles connected by two lines. But, to have a butterfly mesh i need two circles connected by four lines.
The second problem is; ansys always says that one line is attached to an area. What can I do to delete this line.
I am attaching a picture of my not properly meshed model also.
Thanks in advance.
Ali
First problem is; ansys represents my holes(of course those are cylindirical holes) with two circles connected by two lines. But, to have a butterfly mesh i need two circles connected by four lines.
The second problem is; ansys always says that one line is attached to an area. What can I do to delete this line.
I am attaching a picture of my not properly meshed model also.
Thanks in advance.
Ali