Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Insert Flat Pattern in Drawing

Status
Not open for further replies.

billylecaid

Mechanical
Dec 4, 2009
14
I'm currently trying to( as the subject clearly stated :p ) insert a flat pattern in a drawing along with the 3 stantard fully formed view of the same part.

I've already create the new flat pattern instance in the family table of the fully formed part ... and I'm stuck.

I've read somewhere that I should be able to change the model of a view but I don't know to find that function.

Thank you !



I'm French Canadian excuse my English mistake.

Me Fail English that's unpossible - Ralph Wiggum

 
Replies continue below

Recommended for you

Billy, you can add/change the drawing model by going to the File->Properties->Drawing Models->Add Model(select your flat model)->Set Model(select the model you just added) and inset a drawing view as you normally do.
 
Thank you so much!

It did work perfectly!


I'm French Canadian excuse my English mistake.

Me Fail English that's unpossible - Ralph Wiggum

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor