Insert Model Items - Dimensions

[mmlentz]

I typically use this command on a new drawing, after I've set up my views. I do not do it by feature, but by the enitre model. I do NOT check any of the subitems (Marked for Drawing, Instance/Revolution Counts, etc). However, Hole Wizard Profile dimensions always show up (and in large quantities - a diameter and depth for every hole). How can I prevent these from showing up while dimensioning the entire model?

Running SW 2004 SP4.1

Thanks,
Mike

 

[automationbabe]

If you have 'hole wizard profiles' selected, deselect it. Should get rid of most of the diameter problems and the hole depth callout.

 

[mmlentz]

NONE of the subitems (including Hole Wizard Profiles) are selected.

 

[automationbabe]

hmmm....used to happen to me too. Try a repair on SW and see if it goes away? Good luck.