Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inserting A Component Using Multiple Rectangular/Circular Patterns

Status
Not open for further replies.
TorsionalStress

TorsionalStress

Mechanical
May 23, 2005
234
Using Catia V5R19;

Is it possible to insert a component using multiple rectangular/circular patterns?

Any response will be greatly appreciated!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Yes you can use the Re-Use Pattern at the assembly level with different patterns but only 1 at a time.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Med Che
  • Locked
  • Helpful tip
Macro to Count the Number of Leaders Associated with a 2D Component
Replies
5
Views
101
Little Cthulhu
Little Cthulhu
S
Catia 3D F T & A Get value of Dimension using Macro/Vba Proamming
Replies
0
Views
240
sammehta
S
NaWin55
  • Locked
  • Question
Catia create points using Excel data
Replies
5
Views
210
TudorM
TudorM
CB010274
  • Locked
  • Question
Help with CATIA Assembly Component Types
Replies
3
Views
80
Wuzhee
Wuzhee
CarlosR2022
  • Locked
  • Question
How to "Explore" a physical part in 3DExperience using Macro?
Replies
0
Views
95
CarlosR2022
CarlosR2022

Part and Inventory Search

Sponsor

Back
Top Bottom