Interfacing DL-205 with an analog source

[clava]

I have an F2-08AD-1 analog interface module for the Direct Logic DL-205 PLC. I want to connect a 4-20mA signal to it, the signal is already connected to a Honeywell 6300, series controller, i would like to daisy chain this signal to the PLC module, but all that comes to the existing controller is a 2 wire 4-20mA signal, how would i go about connecting this to the PLC.

 

[ctipete]

you can wire them in SERIES but you'll have to recalibrate the first system when done.

 

[sdb830]

One thing to look out for with Autmation Direct Analog modules they are non-isolated!

 

[SteveMeisel]

Here is a link to the Manuals for the DL205 analog cards.

http://www.automationdirect.com/static/manuals/d2anlg/d2anlg.html

Good luck