Internal Inconsistence error on loading a part in NX6

[NXsupport]

Hi All,
NX6.0.2.8..

I have an issue with loading a part which was created in NX6.0.4.3.. Iam getting message "part had internal inconsistencies report to GTAC"..

I know this message is displayed if the part is created in illegal software and trying to load it in illegal software..

Is there any other scenario this message can pop up.. Like in this case, trying to open a part which was created in higher release/version of NX6..

waiting for valuable thoughts on this..

Thanks

 

[JohnRBaker]

I would still contact GTAC since they are only ones with access to the tools needed to resolve this issue.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.