Intersection point detection in FTA

[ocad]

Hallo!
I have a question about the Functional Tolerancing & Annotations module (FTA). In the Drafting module it is possible to use the commando Intersection point detection. I have tried to find that commando in the FTA-module but have not succeeded. I wonder if someone knows if possible to find an Intersection point in the FTA-module?

Thanks to all answers and suggestions.

/Ocad

 

[Runz]

If you are trying to dimension from one plane/surface to the intersection of two other planes/Surfaces that are not parrallel to the first, you can use the "Construction Geometry Creation" tool to create an axis at their intersection. Then create the dimension from the plane/surface to the axis.

If this is not the case, could you explain in more detail.

 

[ocad]

Thanks Runz! It was exactly this commando I were looking for.