Invalid or Unsuitable OM Object

[Peter2001SS]

I'm hoping that someone can help me figure out how to get around this error and has seen this before. We just upgraded to NX 6.0.5.3 MP4 and started seeing the error below just after the upgrade when opening only some files.

Could not open XXXXXX
The following files could not be loaded causing this open to fail:
XXXXX - An operation was attempted on an invalid or unsuitable OM object

Thanks for your help.

 

[looslib]

Contact GTAC! Those errors are very low-level and they are the only ones who have the tools to diagnose the cause.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli

 

[Peter2001SS]

GTAC has been working on this but no solution yet and was wondering if someone here had run into this & worked thru already.

 

[JohnRBaker]

There are 'N' number of reasons for something like this, with 'N' being a very large number. That's why even if someone had encountered a similar error message, the likelihood that it was the result of the same situation as yours would be very low. GTAC's your best route to go.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.